Toshiba e-studio550 Service Manual page 75

No. Message
12 READY
(SADDLE STITCH
TRAY FULL)
13 READY
(SET CORRECT
CASSETTE)
14 READY (ADDING
TONER)
15 READY (CHECK
STAPLER)
16 READY (CHECK
SADDLE STITCH
STAPLER)
17 READY (USE
GENUINE TOSHIBA
TONER)
18 ENTER DEPART-
MENT CODE
19 READY (ADD
INSERTER PAPER)
20 READY (ADD TAB
SHEET)
21 READY (FINISHER
IN USE)
e-STUDIO550/650/810 CONTROL PANEL
State of copier
Ready for scanning
- The copier is ready for scanning and waiting
for the operator to select the copying conditions.
The saddle stitcher is full of paper.
Ready for scanning
- The copier is ready for scanning and waiting
for the operator to select the copying conditions.
Cassette not installed during printing
Ready for scanning
- The copier is ready for scanning and waiting
for the operator to select the copying
conditions.
The receiving tray is full of paper.
Ready for scanning
- The copier is ready for scanning and waiting for
the operator to select the copying conditions.
The finisher unit runs out of the staples.
Ready for scanning
- The copier is ready for scanning and
waiting for the operator to select the
copying conditions.
The saddle stitcher unit runs out of the
staples.
Ready for scanning
- The copier is ready for scanning and
waiting for the operator to select the
copying conditions.
Toner other than Toshiba's has been used.
The copier is waiting for the operator to
enter the department code.
- Displayed when the department manage-
ment function has been used
Ready for scanning
- The copier is ready for scanning and
waiting for the operator to select the
copying conditions.
No inserter paper
Ready for scanning
- The copier is ready for scanning and waiting
for the operator to select the copying
conditions.
No tab paper
Ready for scanning
-The copier is ready for scanning and waiting
for the operator to select the copying
conditions.
Finisher manual operating
Printing is resumed by removing paper
from the saddle stitcher unit.
- Printing is resumed by changing
the setting for cassette selection,
then pressing the [START] key.
- Printing is resumed automatically
when the toner supply is completed.
- Printing is resumed automatically
when the staple cartridge is
replaced with a new one.
- Printing is resumed automatically
when the staple cartridge is
replaced with a new one.
The display is made to disappear by
using the toner provided by Toshiba.
The copier becomes ready to start
copying when the correct depart-
ment code is entered.
Printing is resumed when the
[START] key is pressed under the
condition the printing UI is displayed
([JOB STATUS] key pressed) after
adding inserter paper.
Printing is resumed when the [START]
key is pressed under the condition the
printing UI is displayed ([JOB
STATUS] key pressed) after adding
tab paper.
Printing is started when pressing the
[START] key.
5 - 4
Note
JUNE 2002 © TOSHIBA TEC