Toshiba e-studio550 Service Manual page 188

Note: When installing the top cover, insert the latches
completely and be careful not to catch up
the urethane seal. Also, pay attention to the lap
of the urethane sheets.
[F] Doctor blade
(1) Remove the developer material.
(2) Remove 2 screws and take off the doctor
blade.
Note: When installing the doctor blade, put the both
edges of it against the protrusions at the front
and rear side frames, and tighten up the screws
to fix it.
This procedure makes it unnecessary to adjust
the doctor-sleeve gap.
[G] Auto-toner sensor
(1) Remove the developer material.
(2) Remove 2 screws and take off the auto-toner
sensor.
JUNE 2002 © TOSHIBA TEC
Auto-toner sensor
12 - 15 e-STUDIO550/650/810 DEVELOPER UNIT
Doctor blade
Protrusion