Toshiba e-studio550 Service Manual page 190

[I] Scattered toner recovery roller/Developer
sleeves (magnetic roller)
(1) Remove 3 screws and take off the front side
plate.
(2) Remove the scattered toner recovery roller.
(3) Remove 2 screws of the front side developer
sleeve holder.
(4) Remove the bearing and E-ring and take off
the gear and parallel pin.
(5) Remove 2 screws of the rear side developer
sleeve holder.
(6) Remove both the upper and lower developer
sleeves with the holders.
(7) Take off 2 pole position fixing bushings and
remove 2 E-rings.
JUNE 2002 © TOSHIBA TEC
Front side plate
Developer sleeve holder
Scattered toner recovery roller
Pole position fixing bushing
12 - 17 e-STUDIO550/650/810 DEVELOPER UNIT
Developer sleeve holder
Bearring, E-ring,
Gear, Parallel pin