Toshiba e-studio550 Service Manual page 142

(13)Remove 1 screw and take off the plate spring.
(14)Remove 1 screw (as shown with the white arrow)
from the back side and release the bracket.
(15)Disconnect 1 connector, remove 1 screw and
take off the paper size detection sensor board.
Note: When installing the bracket, install it so that the
pointer of the bracket comes to the position where
it has been before being removed.
Notes: Pay attention to the following things when setting
up the bypass feed roller and pickup roller.
1. Put the clip in the groove of the shaft
completely.
2. Make sure there is no adhesion of oil and
such on the timing belt, pulley and roller.
3. Be careful not to install the bypass pickup
roller and feed roller in a wrong direction.
4. Install the feed roller for the one-way clutch
to come to the rear side.
JUNE 2002 © TOSHIBA TEC
Bracket
Paper size detection sensor board
Feeding
direction
Separation roller
9 - 19 e-STUDIO550/650/810 PAPER FEEDING SYSTEM
Earth plate spring
Connector
Pointer
Feed roller
Pickup roller