Toshiba e-studio550 Service Manual page 221

(4) Remove 2 E-rings and take off the web pushing
roller.
Cautions:
1. Take up the cleaning web a little (3~5 rotations with
hand) after replacing the cleaning web and web
pushing roller.
2. When installing the cleaning web unit to the fuser
unit, make sure that the web is not slacked off.
3. Turn the fuser unit jam access knob 10~15 times to
adapt the cleaning web to the fuser roller. At this
time make sure that there is no defect caused by an
installing inadequacy.
4. Make sure that the cleaning web is not riveled or
slacked off.
5. Set up the PM support "6S" and clear the cleaning
web counter. After clearing it, the web motor
automatically rotates for 65 seconds when turning
the power ON.
6. Turn the power ON and make sure that "READY" is
displayed.
7. Finally confirm the fuser unit is in a proper condition
(same as the above 6).
8. Do not rotate the web motor for more than 2 min. at
the output check (03-124) since the cleaning web
may be slacked off when rolled up.
Note: Approximate remaining web can be seen
through the window at the fuser unit (shown by
the right figure).
JUNE 2002 © TOSHIBA TEC
Pin
Full
Low
14 - 15
E-ring
e-STUDIO550/650/810 FUSER UNIT