Toshiba e-studio550 Service Manual page 236

[F] O-ring
When installing the receiving tray, add the O-rings
(service parts) to the exit roller in order to improve
the paper stacking condition.
(1) Remove 6 screws and take off the exit side
cover.
(2) Remove 2 E-rings and move the 2 bearings
toward the inside.
(3) Move the exit roller to the near side and install 2
O-rings to the grooves of the exit roller.
Note: O-ring: Refer to the parts list for the parts number
and so on.
e-STUDIO550/650/810 EXIT/REVERSE SECTION
E-ring
O-ring
15 - 8
Bearing
JUNE 2002 © TOSHIBA TEC