Toshiba e-studio550 Service Manual page 311

(B-3) ADF left cover
(1) Remove 2 screws and take off the ADF left
cover while moving it downward.
[C] ADF board
(1) Remove 4 screws and take off the rear cover.
(2) Disconnect all 15 connectors from the board.
(3) Remove 1 screw and 2 lock supports and take
off the ADF board.
(4) Remove 2 screws, release the harness from
the clamp and take off the braket.
Note: By disconnecting 15 connectors and removing
3 screws mentioned at the above (2), (3) and
(4), ADF board can be taken off with the bracket.
[D] Rollers
(D-1) Pickup roller/Feed roller
(1) Open the jam access cover.
(2) Remove 2 screws and take off the upper
guide cover.
(3) Remove the clips at the pickup unit, displace
the bushings and take off the pickup unit.
e-STUDIO550/650/810 RADF
ADF left cover
(3)
Clip
16 - 74
(4) Lock support
(4)
ADF board
Upper guide cover
Bushing
JUNE 2002 © TOSHIBA TEC