Toshiba e-studio550 Service Manual page 43

(3) Disconnect 19 connectors to the LGC board.
(4) Remove 6 screws and take off the bracket
with the LGC board.
(5) Disconnect 6 connectors, remove 1 screw,
release 3 lock supports and take off the high-
voltage transformer.
[C] Power supply unit
(1) Remove the SYS board, hard disk and LGC
board with the bracket.
(2) Remove 4 screws and take off the bracket of
the power supply unit.
(3) Disconnect 1 link connector.
(4) Remove 9 connectors and pull out the power
supply unit.
Note: Be careful not for the power supply unit to be
caught by harnesses.
e-STUDIO550/650/810 OUTLINE OF THE MACHINE
High-voltage transformer
Lock support
Link connector (3)
2 - 30
LGC board
JUNE 2002 © TOSHIBA TEC