11) Attach the drum fixing plate and the photoconductor drum.
Apply grease to the inside of the photoconductor drum. (Dia. 2)
Attach the drum from (b). (Prevention against the sub blade
edge breakage)
Attach the drum so that its position with the sub blade is as
shown.
12) Attach the drum cover.
Note: After attaching the drum cover, do not make a copy.
When attaching the drum cover, engage the detection
gear 20T rib with the 30T gear rib, and attach the drum
cover to the process frame.
13) Insert the process unit into the machine until it is fully engaged.
C. Disassembly procedure (Transfer charger unit)
1) Press the side cover open/close button and open the side
cover.
1)
2)
e-STUDIO203S/203SD DISASSEMBLY AND ASSEMBLY 8 - 3
2) Push up the lock pawls (2 positions) of the side cover, and
remove the transfer charger.
Transfer
1)
charger
D. Assembly procedure
For assembly, reverse the disassembly procedure.
E. TC unit cleaning
1) Remove the charger cleaner from the manual paper feed unit.
1)
Lock pawl rear
1)
2)
Lock pawl rear