Toshiba e-studio550 Service Manual page 65

B-1) Misfeed in copier (
• Paper leading edge jam detected by exit sensor
Registration motor turned ON
↓
Exit sensor not turned ON within 0.975 sec.
↓
"Clear paper" symbol (
↓
Copying stopped
• Paper trailing edge jam deteced by exit sensor
Registration motor OFF
↓
Exit sensor not turned OFF within 0.952 sec.
↓
"Clear paper" symbol (
↓
Copying stopped
• Immediately after power is turned ON:
↓
Any of all sensors at transport path detecting paper (ON)
↓
"Clear paper" symbol (
• Front cover opened during copying
↓
"Clear paper" symbol (
• Paper leading edge jam detected by registration sensor
Registration sensor not turned ON within a certain period of time after paper leading edge has
passed transport roller
↓
"Clear paper" symbol (
• When a sheet of paper is fed at reverse section:
Registration sensor not turned ON within a certain period of time after reverse motor has been
turned ON
↓
"Clear paper" symbol (
JUNE 2002 © TOSHIBA TEC
)
) displayed (E01)
) displayed (E02)
) displayed (E03)
) displayed (E41)
) displayed (E20, 22, 25, 30, 34, 3C)
) displayed (E11)
4 - 9
ON
Registration
motor
Exit sensor
Timer
0
Registration
motor
Exit sensor
Timer
0
e-STUDIO550/650/810 GENERAL OPERATION
ON
0.975sec.
Misfeed in copier (E01)
OFF
ON
0.952sec.
Misfeed in copier (E02)