Supplies And User Maintenance; Toner Cartridge Replacement - Toshiba e-STUDIO 12 Operator's Manual

This chapter describes how to replace the toner cartridge.
.

TONER CARTRIDGE REPLACEMENT

When the toner cartridge replacement required ( ) indicator lights up, replacement of the toner
cartridge will be needed soon. Obtain a new cartridge. When the toner cartridge replacement
required ( ) indicator blinks, the toner cartridge must be replaced before copying can be
resumed. Replace the toner cartridge by following the procedure below.
4
Ensure that the bypass tray is open and then open the side cover while pressing the
side cover open button.
Then, push gently on both sides of the front cover and open it.
Push the toner cartridge lock release lever and pull the toner cartridge out.Dispose of
the old toner cartridge in accordance with local regulations.
22

SUPPLIES AND USER MAINTENANCE

Be sure to use only genuine TOSHIBA parts and supplies.
During a long copy run of a dark original, the ready (
the indicator light up, and the copier stop, even though toner is left. The
copier will feed toner up to 2 minutes and then the ready (
light up. Press the print (
After removing the toner cartridge, do not shake it or tap on it. Doing so may
cause toner to leak from the cartridge. Put the old cartridge immediately in
the bag contained in the box of the new cartridge.
) key to restart copying.
Toner cartridge lock release
lever
) indicator may blink,
) indicator will