Toshiba e-studio550 Service Manual page 137

(A-3) Feed clutch/Transport clutch
(1) Release the harness from the harness clamp.
Then remove 1 screw and take off the clutch
cover.
(2) Disconnect 1 connector, remove 1 E-ring for
each clutch and take off the feed and transport
clutches.
Notes: 1. When installing the clutches, pay attention
to the color of harness and fit the stoppers
on them completely.
2. Make sure that the E-rings are tightly fit not
to be loosen and one end of E-ring does not
ride too much on the flat part of shaft.
(A-4) Pickup solenoid
(1) Remove the feed unit for the tandem LCF.
(2) Release the feed clutch and transport clutch.
(3) Remove 2 screws and take off 2 brackets and
2 guides.
(4) Remove 1 screw and take off the bracket.
e-STUDIO550/650/810 PAPER FEEDING SYSTEM
Transport clutch
Harness: purple
Harness: black
Bracket
Guide
9 - 14
Clutch cover
Feed clutch
Guide
JUNE 2002 © TOSHIBA TEC