Toshiba e-studio550 Service Manual page 204

[G] Transport detection sensor
(1) Remove the transfer belt and fuser unit.
(2) Disconnect 1 connector, remove 1 screw and
take off each sensor.
[H] Transport clutch
(H-1) Transport clutch 1, 2
(1) Disconnect 1 connector, remove 1 E-ring and
take off each transport clutch.
Notes: 1. When installing the clutches, pay attention
to the color of harness.
2. Make sure that the E-rings are tightly fit not
to be loosen and one end of E-ring does not
ride too much on the flat part of shaft.
(H-2) Drive clutch
(1) Remove 1 E-ring and 3 screws and release the
bracket.
(2) Disconnect 1 connector and take off the drive
clutch.
Notes: 1. When installing the clutches, pay attention
to the color of harness.
2. When fitting the E-rings on the clutches, make
sure that the latches of E-ring do not
protrude on the flat part of shaft.
JUNE 2002 © TOSHIBA TEC
Transport clutch 2
Black
Drive clutch
13 - 9 e-STUDIO550/650/810 TRANSFER/TRANSPORT UNIT
E-ring
Transport clutch 1
E-ring
Bracket