Toshiba e-studio550 Service Manual page 203

(5) Lift the transfer/transport belt unit and take
off the catch-up section.
Slack off the right slide rail a little.
Push the rail to the inside of the unit.
(6) Change the A or B section to the right hand
and hold the C section with the left hand. Then
lift the transfer/transport unit and take it off.
Notes: 1. Since the guide is sometimes transformed
when being pressured, be careful not to
hold the D section when lifting the transfer/
transport unit.
2. Take the following steps when installing
the transfer/transport unit.
1) Pull out only the left slide rail.
2) Hang the transfer/transport unit on the
left slide rail firmly.
3) Extend the right slide rail fully, especially,
its leading edge.
4) Hang the transfer/transport unit on the
right slide rail firmly.
5) Fix the transfer/transport unit with 2
shoulder screws.
6) Follow the reverse procedure of
disassembling afterwards.
e-STUDIO550/650/810 TRANSFER/TRANSPORT UNIT
1
C
13 - 8
3
2
D
JUNE 2002 © TOSHIBA TEC