Toshiba e-studio550 Service Manual page 101

(2) Move the carriages to the notches of the frame
and take off the exposure lamp with lifting the
rear side of it.
[F] Scanning section control PC board (SLG board)
(1) Remove the original glass and lens cover.
(2) Disconnect 7 connectors, remove 4 screws and
take off the SLG board.
[G] Lens unit
(1) Remove the original glass and lens cover.
(2) Disconnect 2 connectors, remove 2 screws and
take off the lens unit.
Notes: 1. Do not touch the screws shown with the
arrows (8 paint-locked screws) when
changing the lens unit.
2. Handle the lens unit with enough care and
do not touch the adjusted area and lens.
JUNE 2002 © TOSHIBA TEC
Connector [G]
Lens unit
Lens
6 - 17 e-STUDIO550/650/810 SCANNING SECTION
Notch
[F]
[G]
[F]
SLG board
[G]
Adjusted area
[F]
[F]