Toshiba e-studio550 Service Manual page 273

(3) Original jammed not reaching the small original exit sensor (from the small original reverse side)
• Jam detection
This jam is detected during the time after an original reaches the small original reverse sensor
until it reaches the small original exit sensor.
• Jam timer setting
The setting value for the jam timer is the time mentioned above plus necessary time for an original
to proceed 60mm.
(4) Original jammed at the small original exit sensor (from the small original reverse side)
• Jam detection
This jam is detected during the time after the deceleration, which is set to finish at the position
20mm short of the small original exit sensor, starts until an original passes through the small
original exit sensor.
• Jam timer setting
The setting value for the jam timer is the time mentioned above plus necessary time for an original
to proceed 60mm.
16. 6. 6. Jams at intermediate transport section
(1) Original jammed not reaching the intermediate transport sensor
• Jam detection
This jam is detected during the time after an original reaches the 3rd roller until it reaches the
intermediate transport sensor.
• Jam pulse setting
The setting value for the jam pulse is the equivalent number of pulses it takes for an original to
proceed the distance from the 3rd roller to the intermediate transport sensor plus 30mm.
(2) Original jammed at the intermediate transport sensor
• Jam detection
This jam is detected during the time after the trailing edge of an original passes the position 20mm
further from the 3rd roller until it has passed through the intermediate transport sensor.
• Jam pulse setting
The setting value for the jam pulse is the equivalent number of pulses it takes for the trailing edge
of an original to proceed the distance from the position 20mm further from the 3rd roller to the
intermediate transport sensor plus 60mm.
e-STUDIO550/650/810 RADF 16 - 36 JUNE 2002 © TOSHIBA TEC