Toshiba e-studio550 Service Manual page 246

The SCN-STR turns OFF when the trailing edge of the original has passed the scanning section, and
before the trailing edge of the original passes the 3rd roller, 2nd original reaches the scanning waiting
section and stops being transported.
(6) Start of 2nd original scanning
Scanning begins after receiving the original transport signal from the copier. At the same time,the
original stop signal is reset. Then the read motor starts to rotate forward and the large original exit
motor starts to rotate in reverse.
The SCN-SCR turns ON when the leading edge of the original has reached the scanning section. When
the trailing edge of 1st original has proceeded a specified distance after passing the 3rd roller, the large
original exit motor starts to accelerate.
When the leading edge of the original has been transported to the intermediate transport section and
come to a specified distance before the intermediate transport roller, The large original exit motor starts
to rotate in reverse.
JUNE 2002 © TOSHIBA TEC 16 - 9 e-STUDIO550/650/810 RADF