Toshiba e-studio550 Service Manual page 270

(3) Original jammed not reaching the read sensor
• Jam detection
This jam is detected during the time after an original comes to the 1st roller until it reaches the
read sensor.
• Jam pulse setting
The setting value for the jam pulse is the equivalent number of pulses it takes for an original to
proceed the distance from the 1st roller to the read sensor plus 60mm.
(4) Original jammed at the read sensor (from the feeding side)
• Jam detection
This jam is detected during the time after an original passes through the 1st roller until it passes
through the read sensor.
• Jam pulse setting
The setting value for the jam pulse is the equivalent number of pulses it takes for an original to
proceed the distance from the 1st roller to the read sensor plus 30mm.
(5) Original jammed at the read sensor (from the large original exit side)
• Jam detection
This jam is detected during the time after the scanning of an original from the large original exit
side set at the scanning position until the original passes through the read sensor.
• Jam pulse setting
The setting value for the jam pulse is the equivalent number of pulses it takes for the longest
original (LD) to pass through the read sensor and proceed more 30mm.
16. 6. 3. Jams at large original exit section
(1) Original jammed not reaching the large original exit sensor (while discharging)
• Jam detection
This jam is detected during the time after an original comes to the 4th roller until it reaches the
large original exit sensor.
• Jam pulse setting
The setting value for the jam pulse is the equivalent number of pulses it takes for an original to
proceed the distance from the 4th roller to the large original exit sensor plus 30mm.
JUNE 2002 © TOSHIBA TEC 16 - 33 e-STUDIO550/650/810 RADF