Toshiba e-studio550 Service Manual page 139

(2) Remove 1 E-ring, disconnect 1 connector and
release the intermediate transport clutch.
Note: 1.When installing the clutch, fit the stopper on it
completely.
2.Make sure that the E-rings are tightly fit not
to be loosen and one end of E-ring does not
ride too much on the flat part of shaft.
[C] Bypass feed unit
(1) Remove the bypass feed unit.
(2) Remove 1 clip and 1 bushing and displace the
bypass transport roller.
(3) Remove 2 clips and 1 bushing and take off the
pickup/feed roller unit.
(4) Remove 3 clips and take off the pickup roller.
(5) Remove 3 clips and take off the feed roller.
Notes: 1. When installing the rollers, be careful not to
use the bushing of a wrong material.
2. Install the feed roller for the one-way clutch
to come to the rear side.
e-STUDIO550/650/810 PAPER FEEDING SYSTEM
One-way clutch
Plastic bushing
9 - 16
Clip
Feed roller
Metal bushing
Pickup roller
JUNE 2002 © TOSHIBA TEC