Toshiba e-studio550 Service Manual page 262

(9) Reversing and discharging of 1st original
Both the large original exit and read motors start to rotate foward. When the leading edge of the original
has reached the read sensor then been transported a specified distance by the read motor, the
disengagement solenoid turns ON. The large original exit motor stops when the disengagement sole-
noid has turned ON.
When the leading edge of the original has been transported to the large original exit and reached the
3rd roller, and the large original exit motor starts to rotate in reverse.
Feeding of 2nd original begins when the trailing edge of the original has passed the 4th roller.(Same
operation as 16.5.1(4))
When the trailing edge of the original has passed the 4th roller and proceeded a specified distance, the
large original exit motor starts to slow down. When the trailing edge of the original has been detected by
the large original exit sensor and proceeded a specified distance, it stops rotating. Then the original is
discharged.
Both the read and feed motors stop rotating when 2nd original has reached the scanning waiting
position.
JUNE 2002 © TOSHIBA TEC 16 - 25 e-STUDIO550/650/810 RADF