Toshiba e-studio550 Service Manual page 189

[H] Guide roller
(1) Remove the developer unit.
(H-1) Front side
(2) Remove 2 screws and take off the bracket and
3 gears.
(3) Remove 1 E-ring and take off the spring.
(4) Remove 2 E-rings and take off 2 guide rollers.
(H-2) Rear side
(5) Remove 1 E-ring and take off the gear.
(6) Remove 1 E-ring and 1 spring and take off the
bushing.
(7) Remove 4 screws, take off the rear side frame
and disconnect the bias connector.
(8) Remove the bias plate and spring.
(9) Remove 2 E-rings and take off 2 guide rollers.
Note: When installing the guide roller, pay attention to
its color (upside: white, downside: black).
e-STUDIO550/650/810 DEVELOPER UNIT
Bracket
Guide roller
E-ring
Gear
Spring
12 - 16
Spring
E-ring
Bias connector
Bushing
Spring E-ring
Guide roller
Bias plate
JUNE 2002 © TOSHIBA TEC