Toshiba e-studio550 Service Manual page 103

(7) Remove the wires and take off the carriage-2
upward while tilting it.
[I] Scanner motor
(1) Remove the feed side cover and disconnect the
connector of scanner motor.
(2) Release 1 spring, remove 2 screws and take off
the scanner motor with bracket.
Note: Take the following steps when installing the
scanner motor.
1. Temporarily tack the bracket to the frame.
2. Put the spring on the motor and fix it with the
screws at a balanced position.
[J] Carriage home position sensor
(1) Disconnect 1 connector, release latches and
take off the carriage home position sensor.
JUNE 2002 © TOSHIBA TEC
Scanner motor
Carriage home position sensor
6 - 19 e-STUDIO550/650/810 SCANNING SECTION
Spring