Settings In General Setup Menu - Standard Horizon CPN1010i Owner's Manual

The default setting of the Chart Control Icon is Shown Permanent, however this may be
changed by the procedure below:
1. Press the
2. Tap on GENERAL. The General Setup menu appears.
3. Turn the Rotary Knob until CHART CONTROL ICON is highlighted.
4. Tap on CHART CONTROL ICON.
5. Tap on SHOWN.
6. The menu shows Off, 2 Seconds, 5 Seconds, 10 Seconds and Permanent. Tap on
the item you want.
7. Press the
The default place of the Chart Control Icon is on the right top side, however this may be
changed by the procedure below:
1. Press the
2. Tap on GENERAL. The General Setup menu appears.
3. Turn the Rotary Knob until CHART CONTROL ICON is highlighted.
4. Tap on CHART CONTROL ICON.
5. Tapping on LOCATION selects between Left and Right.
6. When the item you want has been selected, press the
menu disappears.

SETTINGS IN GENERAL SETUP MENU

The General Setup menu has other selections that allow you to customize the display. All
selections are listed in the following table:
TIME SETUP
DATE FORMAT
PAGE SWEEP
KEYPAD BEEP
SHUTTLE POINT ENTER
UNITS OF MEASURE
DISPLAY COLOR
CURSOR SPEED
CPN700i and CPN1010i Multimedia Chart Plotters
key, tap on Setup Menu.
key repeatedly until the menu disappears.
key, tap on Setup Menu.
Selects the Time Zone offset, enable or disable Daylight Savings time, selects the
Time Format and switch between 12 or 24 hours time format.
Selects the Date format among MM-DD-YY (default), DD-MM-YY or YY-MM-DD.
Selects among Animated (default), Normal and Off the swipe control to change page.
Allows the beep produced when a key is pressed to be turned On (default) or Off.
ShuttlePoint Knob press is user selectable. When set to On (default), pressing the
ShuttlePoint Knob in the center is equal to confirm action. When set to Off, pressing the
ShuttlePoint Knob in the center will not produce any effect.
Units of Measure can be selected for Distance, Speed, Depth, Altitude and Temperature:
Distance: selections are Nm (Nautical Miles), Sm (Statue Miles), Km (Kilom-
eters), Nm+Ft, Nm+Mt. Note when "Nm+Ft" is selected if the distance is less
than 1.0 Nm, it turns to Feet. When "Nm+Mt" is selected if the distance is less
than 1.0 Nm, it turns to Meters.
Speed: selections are Kts (knots), MPH (miles per hour), Kmh (kilometer per
hour).
Depth: selections are Ft (feet), FM (fathoms) and Mt (meters).
Altitude: selections are Ft (feet) and Mt (meters).
Temperature: selections are F (Fahrenheit) and C (Celsius).
Changes the background colors to enhance the visibility of the screen depending on the
surrounding light conditions. Normal (default) is recommended when the CPN Series
Chart Plotter is not exposed to the direct sunlight. When this mode is set the charts are
displayed in order to use colors as similar as possible to ones used in the original paper
charts. Night is recommended when the environment is dark in order to reduce the glare
of the display. Sunlight is designed to enhance the visibility of the screen when the CPN
Series Chart Plotter is exposed to sunlight. Classic uses vivid chart colors presentation.
NOAA allows setting NOAA paper chart colors presentation.
Selects the speed among Low, Medium (default) and High for the cursor in the CHART
page and within the MENU.
key repeatedly until the
Page 37