Chart Settings - Standard Horizon CPN1010i Owner's Manual

Safe Depth
Depth Range Min
Depth Range Max

Chart Settings

Settings that control how the chart features will be shown on the Chart Page of the CPN
Series Chart Plotter.
Lat/Lon Grid : Turns the Latitude and Longitude grid lines On (see A) or Off (see B) on the Chart Page.
Boundaries Mode : Selects the Boundaries Mode Auto (only the boundaries of the four next levels are shown) or
Manual (all boundaries are shown). Boundaries Mode applies both to the standard Chart
Boundaries and to VAD Boundaries.
Chart Boundaries : Turns the Chart Boundaries On (see A) or Off (see B). The Chart Boundaries are the "ticked" boxes
surround the coastline. Each box indicates an area where more detail is available. The Chart Boundaries
are shown with a C-MAP 4D SD CARD or without (shows coverage area of Built-In Charts
1 Only for America users.
While the Boundaries Mode and Chart Boundaries settings are set to Manual and On, respectively,
depending on the chart area being displayed and the current zoom level, some degradation in the
performance of the CPN Series Chart Plotter may be experienced. If this occurs, it will also be visible as
reduced response when using the menus: for example, when a menu item is selected the item might not
respond for several seconds. The Boundaries Mode setting of Auto, with Chart Boundaries set to On,
provides a combination believed to be adequate for the majority of situations where you want to display
the Chart Boundaries.
CPN700i and CPN1010i Multimedia Chart Plotters
: In Safe mode, it's necessary to set the value for the Safe Depth to identify safe and unsafe
area. If this value isn't set, all depth areas appear with the same color. Sets the value in the
range 0 - 1000Ft. The default setting is 15Ft.
: Sets the minimum depth limit for Spot Soundings and Depth Contours.
: Sets the maximum depth limit for Spot Soundings and Depth Contours.
1
).
Page 91