Routes - Standard Horizon CPN1010i Owner's Manual

9. Turn the Rotary Knob to the right to select the Mode field and press the
Knob.
1 It is possible to use the
SHUTTLEPOINT ENTER item (in "Settings in General Setup Menu" paragraph, "Chart Plotter" section)
is set to On, so pressing the
10. You can choose among SHOW to show on the chart the name and icon of Mark, ICON
to show on the chart only the icon of Mark or HIDE to hide on the Chart Page the created
Mark. Tap on the desired mode to show the Mark.
11. Press the
12. Press the
After entering in a Mark it is a good practice to backup the points to a SD CARD.

ROUTES

A Route can consist of Waypoints or Marks. The difference is when a Route is made using
Waypoints and the Route is deleted the Waypoints are also deleted. However if a Route is
made of Marks and the Route is deleted the Marks stay in memory.
See the example below that shows how the CPN Series Chart Plotter switches from one
Waypoint to another.
CPN700i and CPN1010i Multimedia Chart Plotters
ShuttlePoint Knob in place of the
ShuttlePoint Knob in the center is equal to confirm action.
key to save the created Mark.
key again and the new Mark appears on the Chart Page (see E).
Rotary Knob. Make sure that the
Rotary
Page 65