Mounting The Optional External Gps Antenna; Flush Mounting The Antenna - Standard Horizon CPN1010i Owner's Manual

Multimedia gps chart plotters
Hide thumbs Also See for CPN1010i:
Table of Contents

Advertisement

MOUNTING THE OPTIONAL EXTERNAL GPS
ANTENNA
An external WAAS GPS antenna is available when the CPN Series Chart Plotter is flush
mounted or mounted in an area where satellite reception is not possible with the internal
antenna. This antenna is designed to be mounted on a base, installed on an extension or
flush mounted.
Choose a location for the antenna that has a clear view of the sky and is not located within
3Feet of a Radar or other transmitting antennas. Ensure there are no major obstructions or
fixtures in the immediate proximity to the antenna. The antenna relies on direct "line of sight"
satellite reception. If you are unsure of the chosen location, temporarily mount the antenna
in the desired location to verify correct operation. If mounted close to Radar, after the CPN
Series Chart Plotter has a fix, turn on the Radar to ensure the CPN Series Chart Plotter holds
the fix (use the GPS Status Page).
The thread used on the antenna is an industry standard (1inch 14TPI) used on a wide range
of mounting brackets.
The antenna cable can be cut and spliced to ease installation. Care must be taken when reconnecting
the antenna cable to protect from water and corrosion.

FLUSH MOUNTING THE ANTENNA

Before drilling holes, it is recommended the antenna be positioned where the location is planned, cable
connected to the CPN Series Chart Plotter and power turned on to ensure a GPS Fix is received.
1. To ease installation a flush mounting template for the antenna has been included.
2. Apply the mounting template sticker to the area that was verified for GPS reception.
3. Then, drill out the 0.78" (20mm) and 0.13" (3.2mm) holes, and remove the template.
4. Insert the cable into the 0.78" (20mm) hole and route to the CPN Series Chart Plotter.
5. Apply a small amount or RTV to the underside of the antenna and place onto mounting
surface. Allow time for the antenna to adhere to the mounting surface.
CPN700i and CPN1010i Multimedia Chart Plotters
Page 141

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cpn700i

Table of Contents