Using The Shuttlepoint Knob; Goto Mark - Standard Horizon CPN1010i Owner's Manual

4. The SELECT ROUTE window will be shown (see B).
5. Select the desired Route by moving the
Rotary Knob to left/right or touching the scroll bar up/down and tap on it.
If an empty row has been selected, a Warning window appears, tap on
6. On the Chart Page, a circle with a Flag is shown on the first leg of the Route you chose
and a navigation line is shown, indicating the CPN Series Chart Plotter is navigating to the
first Waypoint in the Route (see C).
Using the ShuttlePoint Knob
1. On the Chart Page move the
point (or any Waypoint in the Route) of the Route.
2. Press the
3. Press the

GOTO MARK

1. Move the ShuttlePoint Knob to an open position no buoy, waning etc. under the cursor
on the Chart Page.
2. Press the
3. Tap on MARK to show the MARKS/WAYPOINTS List.
4. Tap on the desired Mark or Waypoint and press the
5. You will notice a circle is drawn around the Icon Symbol. This means the CPN Series
Chart Plotter is now navigating to the point.
6. Press the
The CPN Series Chart Plotters can start navigating to the cursor location, a saved Mark or any Waypoint
in a Route simply by touching the display or moving the cursor using the
on the display to a location or on the top of a Mark or Waypoint on the chart and pressing the
Page 76
ShuttlePoint Knob until the cursor reaches the starting
key to start following the Route.
key twice to revert to Home mode.
key to show the GOTO popup window.
key to close the Marks/Waypoints page.
ShuttlePoint Knob up/down or turning the
key.
.
ShuttlePoint Knob or tapping
Owner's Manual
key.