Customizing Data Box In The Nmea Display Page; Nmea Data Page - Standard Horizon CPN1010i Owner's Manual

When going to a destination, 3 BOXES is useful to navigate as to get to the destination keep
the Course Over Ground (COG) and Bearing (BRG) figures the same.

Customizing data box in the NMEA Display Page

To customize data box please follow the procedure below:
1. Select a NMEA Display page, then press and hold the
will be highlighted in yellow, release the
2. Tap on the window to be changed to show a selection popup window.
3. Tap on desired selection.
4. A window will be shown with available options. Tap on the desired option.
5. Press the

NMEA Data Page

The NMEA Data page is very useful to see if a external device (example: Depth
Sounder) is transmitting NMEA sentences to the CPN Series Chart Plotter. This page
can also be used to see if the CPN Series Chart Plotter NMEA output is being loaded
down by a external NMEA device the CPN Series Chart Plotter is connected to.
Scenario: VHF Radio connected but the Radio is not receiving a GPS Position.
Usually the VHF Radio will be connected to the Green and Brown wires.
To check to see if the CPN Series Chart Plotter is transmitting the sentences:
1. Connect the BLUE Wire on the
wire and the VHF wire.
2. Press the
3. Tap on DATA. The display should look similar to the following picture.
Page 96
key one time so yellow highlight is removed from the data window.
CPN Series Chart Plotter
key, tap on NMEA.
key. One of the data boxes
key.
to the junction of the Brown
Owner's Manual