of the data boxes will be highlighted in yellow.
2. Tap on the yellow highlighted window to show a selection popup window.
3. Tap on TLOG.
4. A window will be shown with Nm (Nautical Mile), Sm (Statute Mile), Km (Kilometer),
Nm+Ft, Nm+Mt and RESET. Tap on the desired units of measure.
5. Press the
SETUP / RESET
When Trip Log is selected in one of the data windows and you want to reset the log:
1. Press and hold the
2. Tap on TLOG.
3. A window will be shown. Tap on TLOG.
4. Another window will be shown. Tap on RESET.
5. A Warning window will be shown to confirm if you want to reset the Trip Log. Tap on
.The Trip Log is now reset.
6. Press the
USER SD CARD
An optional SD CARD can be used to backup Marks, Routes, and Tracks stored in your CPN
Series Chart Plotter's memory. In this case the SD CARD is similar to a backup disk used
with a PC. The SD CARD is useful to backup User Points when the RAM has to be cleared
to resolve an issue or load new software, or if you would like to transfer Waypoint, Track
and Route information from one STANDARD HORIZON CPN Series Chart Plotter to
Page 80
key one time so yellow highlight is removed from the data window.
key until a field is highlighted (it will be shown in a yellow frame).
key three times to store and exit the editing mode.
Owner's Manual