Assigning Page Soft Keys; Time Setup - Standard Horizon CPN1010i Owner's Manual

· Long press: shows the page Soft Keys. To change the page, tap on the desired Soft
Key, refer to the image below: tap on the
Compass page.
The pages defined on the Soft Keys are used to define the page change cycle.

Assigning Page Soft Keys

The default pages are:
The page Soft Keys can be individually customized from the default pages:
1. To change, press and hold the Page Change Key
then remove your finger.
2. Press and hold the page Soft Key you want to customize (see B). A popup window will
be shown with the available pages (see C).
3. Touch the desired page to select and assign the page to the Soft Key.

Time Setup

The time information supplied by the GPS satellites is in Universal Time Coordinates (UTC or
Greenwich Mean Time). To change the CPN Series Chart Plotter to read the correct time, first you
must figure out the offset and if it is Daylight Saving Time. For example on the West coast of the
United States or Pacific Standard Time the offset needed would be –08:00 or –07:00 for Daylight
Saving Time, Eastern Standard Time –05:00 or –04:00 for Daylight Saving Time. The Time Setup
menu allows you to enter a time zone offset for your location, selection to automatically adjust the
time for Daylight Saving and to configure the time in 12 or 24 hour formats.
Page 32
Soft Key to change to the
(see A) until Soft Keys are shown,
Owner's Manual