Battery Connections - Standard Horizon CPN1010i Owner's Manual
Multimedia gps chart plotters
Hide thumbs
Also See for CPN1010i:
- Owner's manual (188 pages) ,
- Operation manual (32 pages) ,
- User manual (32 pages)
Table of Contents
Advertisement
BATTERY CONNECTIONS
1. The CPN Series Chart Plotter is supplied with a fuse and holder. This fuse should be
installed into the Black wire to protect the NMEA Output/Input circuits from becoming
damaged, however it can also be installed in the red wire.
2. Two Accessory cables (exactly the same cable) are supplied with the CPN Series Chart
Plotter.
3. Connect one of the Accessory cables to the PWR ACC 1 connector on the rear panel.
The other Accessory cable is used to connect to ACC 2 connector.
4. This cable has many wires, however only the RED and BLACK wires are used to
connect to a switched battery supply. Refer to the following images. For additional
connections refer to NMEA 0183 Connections section.
CPN700i and CPN1010i Multimedia Chart Plotters
Page 143
Advertisement
Table of Contents
