Selecting Coordinate System; Loran Td; Changing The Display Color - Standard Horizon CPN1010i Owner's Manual

Selecting Coordinate System

GPS Coordinates may be changed to show Latitude/Longitude (default ddd.mm.mmm),
Loran TDs or UTM. To change the Coordinate System, follow the procedure below:
1. Press the
2. Tap on ADVANCED. The Advanced Setup menu appears.
3. Tap on NAVIGATE. The Navigate menu appears.
4. Tap on COORDINATE SYSTEM.
5. Tap on the desired coordinate type.
6. Press the

Loran TD

1. Press the
2. Tap on ADVANCED. The Advanced Setup menu appears.
3. Tap on NAVIGATE. The Navigate menu appears.
4. Tap on COORDINATE SYSTEM.
5. Tap on TD.
6. Tap on CHAIN and turn the
7. Tap on PAIR and turn the
8. Press the
If the TD numbers are not show correctly on the Chart Page, the Pair letters may be backwards. Reversing
the two letters usually solves this issue. Example Y/Z change to Z/Y.

Changing the Display Color

The CPN Series Chart Plotter has preprogrammed settings allowing you to customize the
look of the pages. The default is Normal.
1. Press the
2. Tap on GENERAL. The General Setup menu appears.
3. Tap on DISPLAY COLOR. A popup window will be shown with the available options
Normal, Classic, NOAA, Night and Sunlight.
Page 34
key, tap on Setup Menu.
key 3 times to show the last selected page.
key, tap on Setup Menu.
Rotary Knob to select the Chain then tap on the number.
Rotary Knob to select the Pair then tap on the letters.
key 3 times to show the last selected page.
key, tap on Setup Menu.
Owner's Manual