Simulation; Navigating A Route In Simulation Mode - Standard Horizon CPN1010i Owner's Manual

The Grounding Alarm function checks the objects that belong to the standard charts. It does not check
the objects belong to the VAD categories.
The Grounding Alarm function is available only if a C-MAP 4D SD CARD is inserted. It also affects the
screen redraw speed so we suggest to disable it when not used.
When any of the objects checked are found for the first time, the CPN Series Chart Plotter shows a pop
up window to alert the user of the possible danger. The name of each new dangerous object found is
reported in the warning window. In the Grounding Alarm Report page the relative item has a tick marker
next to it, to identify the dangerous object currently detected. If in the next search cycle the same objects
are found again, the alarm window will not be shown. Instead, if in the next searches the objects found
before are no longer detected, their relevant item in the Grounding Alarm Report page is cleared (note
that in this case, if the same object type is found again later, the Alarm will be shown). The CPN Series
Chart Plotter shows an icon on the charts that identifies when a Grounding Alarm is detected.

SIMULATION

The built-in Simulator function allows you to become proficient in the use of the CPN Series
Chart Plotter. No current position fix is required because the CPN Series Chart Plotter
simulates position data internally.
Simulation Mode:
Course:
Speed:
Date:
Time:
Cursor Control:
Demo Mode:

Navigating a Route in Simulation mode

This selection allows you to navigate to a saved Route to see how data windows on the Chart
Page and operation of the Compass and Highway pages.
CPN700i and CPN1010i Multimedia Chart Plotters
Three selections:
Off: turns the Simulation Mode off
On: enables the Simulation Mode, where the speed and course are adjusted by entering
in values in the Course and Speed selection discussed later in this table
Route: allows you to navigate to a saved Route
Allows entry of simulated course.
Allows entry of simulated speed.
Allows entry of simulated date.
Allows entry of simulated time.
Enables (On)/disables (Off) the Cursor Control. Moving the
down will change the SOG and left or right will change the COG of the simulated vessel.
In Demo mode the CPN Series Chart Plotter automatically places a Destination point on the
Chart page in the cursor location and simulates navigation to the point. Also, the page
changes automatically every 10 seconds. The pages are shown in the following order: Main
Menu pages, General Chart Page, Highway Page, Compass Page, Tide Page, Chart/Fish
Finder, GPS Status Page, chart pages. Once the Demo mode is enabled, pressing any key
it is possible to temporally exit and returns to CPN Series Chart Plotter normal operation,
but if you do not touch any key for 30 seconds Demo mode restarts.
ShuttlePoint Knob up or
Page 105