Settings In General Setup Menu - Standard Horizon CPN700i Owner's Manual

The Chart Control Icon display duration can be adjusted from Off, 2 sec, 5 sec, 10 sec and
Permanent (default). If Off is selected the Chart Control Icon will not be displayed. If 2 sec,
5 sec, or 10 sec is selected the Chart Control Icon will be displayed for the selected duration.
Tap the touch screen to make the Chart Control Icon reappear. To adjust the duration of the
Chart Control Icon follow the procedure below:
1. Press the
2. Tap on GENERAL. The General Setup menu appears.
3. Turn the rotary knob until CHART CONTROL ICON is highlighted.
4. Tap on CHART CONTROL ICON.
5. Tap on SHOWN.
6. The menu shows Off, 2 sec, 5 sec, 10 sec and Permanent. Tap on the desired duration.
7. Press the
The Chart Control Icon can be adjusted from left side (default) of the Chart display to the
right. To adjust the location of the Chart Control Icon follow the procedure below:
1. Press the
2. Tap on GENERAL. The General Setup menu appears.
3. Turn the rotary knob until CHART CONTROL ICON is highlighted.
4. Tap on CHART CONTROL ICON.
5. Tap on LOCATION to select between Left and Right.
6. When the desired location has been selected, press the
menu disappears.
2.1.4

SETTINGS IN GENERAL SETUP MENU

The General Setup menu allows you to customize the display. All selections are listed in the
following table:
Time Setup
Date Format
Page Sweep
Keypad Beep
Shuttle Point Enter
Units of Measure
CPN700i and CPN1010i Multimedia Chart Plotters
key, tap on Setup Menu.
key repeatedly until the menu disappears.
key, tap on Setup Menu.
: Selects the Time Zone offset, enables or disables Daylight Saving time, selects 12 or
24 hour Time Format.
: Selects the Date format MM-DD-YY (default), DD-MM-YY or YY-MM-DD.
: Selects Animated (default), Normal and Off the page sweep control.
: Adjusts keypad beep On (default) or Off.
: ShuttlePoint knob press to enter is user selectable. When set to On (default), pressing
the ShuttlePoint knob in the center will enter or confirm the action. When set to Off,
pressing the ShuttlePoint knob in the center will not produce any effect.
: Units of Measure can be selected for Distance, Speed, Wind Speed, Depth,
Altitude, Temperature, Air Pressure, Oil/Boost Pressure and Fuel:
Distance: selections are Nm (Nautical Miles), SM (Statute Miles), km (Kilom-
eters), Nm+ft, Nm+m. Note when "Nm+ft" is selected if the distance is less than
1.0Nm, feet will be displayed. When "Nm+m" is selected if the distance is less
than 1.0Nm, meters will be displayed. The default setting is Nm.
Speed: selections are kn (knots), mph (miles per hour), km/h (kilometers per
hour). The default setting is kn.
Wind Speed: selections are kn (knots), m/s (meters per second), km/h
(kilometers per hour), bft (Beaufort). The default setting is kn.
Depth: selections are ft (feet), ftm (fathoms) and m (meters). The default setting
is ft.
Altitude: selections are ft (feet) and m (meters).The default setting is ft.
Temperature: selections are °F (Fahrenheit) and °C (Celsius).The default
setting is °F.
key repeatedly until the
Page 37