Marks/Waypoints (User Points) List - Standard Horizon CPN1010i Owner's Manual

There is also an easier way to start moving a Mark or Waypoint: press the
cursor is over a Mark point or a Waypoint. Then tap on the desired position and press the
Knob.
If the CPN Series Chart Plotter was in 3D mode, it will automatically change to 2D mode and remain there
after the change has been made.

MARKS/WAYPOINTS (USER POINTS) LIST

The Marks/Waypoints List page shows all the Marks and Waypoints that have been stored
into the CPN Series Chart Plotter. To show the User Points List:
1. Press the
2. Tap on MARKS. The Marks/Waypoints List page will be shown.
This page also allows you to:
Allows sorting by icon type. Selections are:
SELECT: only User Points with the selected icon are shown
ALL: all User Points are shown
Searches through the Marks or Waypoints to find a point by name. The touchscreen keyboard appears
to insert the desired name.
Shows (locates) the position of a Mark or Waypoint on the Chart Page
Allows you to edit a previous stored Mark or Waypoint
Allows sorting the name of User Points. Selections are:
A-Z ASCENDING: sorts the name of the Mark or Waypoint in ascending order
Z-A DESCENDING: sorts the name of the Mark or Waypoint in descending order
Creates a new Mark under the cursor position.
This selection controls how the Marks or Waypoints are shown on the Chart Page. Selections are:
SHOW: icon and name are shown
ICON: only icon (no name) is shown
HIDE: Mark or Waypoint is hidden
SHOW ALL: all Marks or Waypoints are shown
ICON ALL: all Icons are shown without name
HIDE ALL: all Marks or Waypoints are hidden
CPN700i and CPN1010i Multimedia Chart Plotters
key, tap on User Points.
or the key while
ShuttlePoint
Page 63