Table of Contents
Advertisement
1. To change, momentarily press any of the Soft Keys, then press and hold the Soft Key
you want to customize.
2. A popup window will be shown with the above settings.
3. Move the ShuttlePoint knob up or down to select the desired page.
4. Press [ENT] or move the ShuttlePoint knob to the right to save the page to the selected
Soft Key.
3.8
SETTINGS IN GENERAL SETUP MENU
The GENERAL SETUP menu has other selections that allow you to customize the display.
All selections are listed below:
TIME SETUP
DATE FORMAT
COURSE UP/NORTH UP
KEYPAD BEEP
UNITS OF MEASURE
NAV AIDS PRESENTATION Allows the Nav-Aids presentation to be drawn using NOAA symbology when US (default)
DISPLAY COLOR
CP390i and CPF390i
Figure 3.7 - Window options of the selected Soft Key
Select the Time Zone offset, enable or disable Daylight Savings Time and select the
Time Format and switch between 12 or 24 hours time format.
Select the Date format among MM-DD-YY (default), DD-MM-YY or YY-MM-DD.
Select North Up (the top of the page is fixed to North) or Course Up (the top of the page
is orientated to the direction the vessel is heading. This is the default).
Allows the beep produced when a key is pressed to be turned On (default) or Off.
Units of Measure can be selected for Distance, Speed, Depth, Altitude and Temperature:
Distance: selections are Nm (Nautical Miles), Sm (Statue Miles), Km (Kilome-
tres), Nm+Mt, Nm+Ft. Note when "Nm+Ft" is selected if the distance is less
than 1.0 Nm, it turns to Ft. When "Nm+Mt" is selected if the distance is less than
1.0 Nm, it turns to Meters.
Speed: selections are Kts (knots), MPH (miles per hour), Kmh (kilometre per
hour).
Depth: selections are Ft (feet), FM (fathoms) and Mt (meters).
Altitude: selections are Ft (feet) and Mt (meters).
Temperature: selections are F (Fahrenheit) and C (Celsius).
is selected or International symbols when International is selected. When selected these
functions affect how the icons for Lights, Signals, Buoys and Beacons are displayed.
Changes the background colors of the chart page to enhance the visibility of the screen
depending on the surrounding light conditions. Normal is recommended when the GPS
Chart Plotter is not exposed to the direct sunlight. When this mode is set the charts are
displayed in order to use colors as similar as possible to ones used in the original paper
charts. Classic uses vivid chart colors presentation. NOAA allows setting NOAA paper
chart colors presentation. Night is recommended when the environment is dark in order
to reduce the glare of the display. The GPS Chart Plotter displays charts and screen in
Page 37
Advertisement
Table of Contents
