Chart Plotter Controls; Keys - Standard Horizon CPN1010i Owner's Manual

A. Tap on DISPLAY COLOR. A popup window will be shown with the available options.
To set Normal palette tap on Normal.
or
B. Move the ShuttlePoint Knob up/down to highlight DISPLAY COLOR and press the
ShuttlePoint Knob. A popup window will be shown with the available options. To set
Normal palette move the
the ShuttlePoint Knob.
or
C. Move the Rotary Knob left/right to highlight DISPLAY COLOR and press the
Rotary Knob. A popup window will be shown with the available options. To set Normal
palette move the
Knob.

CHART PLOTTER CONTROLS

KEYS

The CPN700i and CPN1010i in addition to being able to control functions with the touch
display, for your convenience dedicated keys and knobs are also provided. You will notice
when a key is pressed a single beep will be produced which means the key press is valid.
When a key press is not valid the CPN Series Chart Plotter will produce 3 beeps.
The key
· Pressing from any page in the Chart Plotter Mode opens the Main Menu.
· Pressing and holding for 3 seconds allows you to change the fields contained within the
data windows.
·
ONLY FROM THE START UP SCREEN
Touchscreen Calibration mode.
The key
· When pressed, exits from a menu, from a selection, closes a Soft Key, changes from
Cursor Mode to Home Mode or exits from a page to the Chart Page.
The key
C
ACTIVE ONLY IN HART
· While on the Chart Page, press the
· When pressed, a popup window will be shown allowing you to start navigating to the
position of the Cursor, a saved Mark or Route.
· To stop navigating, press the
Page 20
ShuttlePoint Knob up/down to highlight Normal and press
Rotary Knob left/right to highlight Normal and press the
: Pressing and holding for 5 seconds enables the
P
LOTTER MODE
key when you desire to Goto to a destination.
key and tap on .
Owner's Manual
Rotary