Gps Cable; Gps Antenna Connections - Standard Horizon CP500 Owner's Manual

2.3.1

GPS cable

The following table is to be used as a reference.
Smart GPS Cable
Pin Wire Color
1 Red
2 Green
3 Brown
4
5
6 Black/Yellow
2.3.2

GPS antenna connections

2.3.2.0 PWR & ACC 1 Cable
BATTERY CONNECTIONS
1. The CP500 is supplied with a fuse and holder. This fuse should be installed into the Black
wire to protect the NMEA Output/Input circuits from becoming damaged, however it can
also be installed in the red wire.
2. Two Accessory cables (exactly the same cable) are supplied with the CP500.
3. Connect one of the Accessory cables to the PWR ACC 1 connector on the rear panel.
The other Accessory cable is used to connect to ACC 2 connector.
4. This cable has many wires, however only the RED and BLACK wires are used to
connect to a switched battery supply. Refer to the image below. For additional
connections refer to NMEA connections.
Switch
Black
-
+
BATTERY
Green
Blue
Brown
Gray
White
Yellow
CP500
Description
Battery Positive
Smart GPS NMEA Output
Smart GPS NMEA Input
NC
NC
Battery Ground
Fuse
Red
PWR ACC 1 Cable
GPS ANT PWR & ACC 1 ACC 2 VIDEO OUT VIDEO IN 1
GPS ANT PWR & ACC 1 ACC 2 VIDEO OUT VIDEO IN 1
R
VIDEO IN 2
VIDEO IN 2
Page 15