Connections; Cp180/Cp180I Connection Table - Standard Horizon CP180 Owner's Manual

Smart GPS Cable
Pin Wire Color
1 Red
2 Green
3 Brown
4
5
6 Black/Yellow
2.4

CONNECTIONS

The GPS Chart Plotter has connectors that are used to connect to the power supply, GPS
antenna (CP180
AND
to NMEA devices* such as VHFs, AIS Receivers, digital instruments and Autopilots.
The GPS Chart Plotter can send many sentences to external NMEA devices*. The NMEA Output
wires are yellow and white. If you have connected devices as shown in the table on the next page
and need to feed NMEA to other devices (Autopilot, Radar...) you can parallel wires from the yellow,
brown or white wires to other devices.
RS232 not opto-isolated electrical interface
2.4.0

CP180/CP180i Connection Table

12VDC Power cable
Pin Wire Color Description
1 Black Battery Ground
2 Red Battery Positive
3 Green NMEA Common
4 Blue Port1 Input
5 Brown Port1 Output
6 Grey Port2 Input
7 White Port2 Output
8 Yellow Port3 Output
When an optional AIS Receiver is connected, Port1 (or other Port the AIS is connected to) of the
NMEA In/Out Connections menu must be changed to AIS 38400 as shown below for communica-
tions. When AIS 38400 is selected the Output Port is disabled.
1. From the Chart page, press [MENU], move the ShuttlePoint knob to highlight SETUP MENU
and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move the
ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT1 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
GPS Chart Plotters
Description
Battery Positive
Smart GPS NMEA Input
Smart GPS NMEA Output
NC
NC
Battery Ground
CP300 ), optional FF525 50/200kHz Black Box Fish Finder and
ONLY
Connection Example
Connect to Battery Ground
Connect to Battery Positive
Common (ground) for NMEA devices***
Connect to Output of NMEA devices*** Default is NMEA-0183*
Connect to Input of NMEA devices***
Connect to FF525
Connect to FF525
Connect to Input of NMEA devices***
NOTE*: AIS RECEIVER OPTION
NOTE
NOTE*
Additional Comments
Default is NMEA-0183 with GGA, GLL, RMC,
DBT, DPT, MTW, VHW and XTE sentences
Default is Fish Finder
Default is Fish Finder
Default is NMEA-0183 with APA, APB, BOD,
GGA, GLL, RMC and BOD sentences**
Page 17