7.1.1
BATTERY CONNECTIONS
1. The CPN Series Chart Plotter is supplied with a fuse and holder. This fuse should be
installed into the Black wire to protect the NMEA-0183 Output/Input circuits from
becoming damaged, however it can also be installed in the red wire.
2. Two accessory cables (exactly the same cable) are supplied with the CPN Series Chart
Plotter.
3. Connect one of the accessory cables to the PWR/ACC1 connector on the rear panel.
The other accessory cable is used to connect to ACC2 connector.
4. This cable has many wires, however only the Red and Black wires are used to connect
to a switched battery supply. Refer to the following images. For additional connections
refer to Par. 7.1.2 "NMEA-0183 Connections".
CPN700i and CPN1010i Multimedia Chart Plotters
Page 153