Nikon Eclipse Ni-E Instruction Manual page 9

1 Do not disassemble.
Disassembling this product may result in electric
shock or malfunction. Malfunction and damage
due to disassembling or modification are
unwarranted.
Do not disassemble parts other than those
described in this manual. If you experience
problems with this product, contact your nearest
Nikon representative.
2 Read the instruction manuals carefully.
To ensure safety, thoroughly read this manual and
the manuals for other equipment to be used with
this product. Particularly, all warnings and
cautions given at the beginning of each manual
must be observed.
Safety is a top design priority for Nikon products.
Safety is ensured as long as the user observes all
of the warnings and cautions given in the
manuals, and uses the system only for its
intended purpose. However, failure to heed the
warnings and cautions given in the manuals,
subjecting the system to shock or impact, or
attempting to disassemble the system may result
in unexpected accidents and injury.
Product with NI-FLEI epi-fluorescence
attachment:
The light source used for Epi-fluorescence
microscopy (HG Precentered Fiber Illuminator)
requires special care during handling because of
its characteristics. Be sure to refer to the manual
for the light source being used.
3 Notes on the power cord
Be sure to use the specified power cord. Use of
other power cords may result in malfunction or
fire. This product is classified as having Class I
protection against electric shock. Make sure this
product is connected to an appropriate protective
earth terminal.
See Chapter 4 "2. Performance Properties" in the
"Assembly/Maintenance" instruction manual for
details on the designated power cords.
● To prevent electric shock, always turn off the
power switch (press to the "O" position) for the
microscope before connecting or disconnecting
the power cord.
Safety Precautions
WARNING
4 Heat from the illuminator
During and immediately after a period of
illumination, the lamp and surrounding areas
(including the lamphouse) are very hot.
● Do not touch the lamp or surrounding areas
during or immediately after a period of
illumination. There is a risk of burn if you touch
the hot area.
● Always attach the lamphouse cover when using
this product.
● Make sure the lamp and surrounding areas
have cooled sufficiently (which may take
approx. 30 minutes) before attempting to
replace the lamp.
● To avoid the risk of fire, do not place fabric,
paper or highly flammable volatile materials
such as gasoline, petroleum benzine, paint
thinner, or alcohol near the lamphouse while
the lamp is lit or for a period of approximately
thirty minutes after the lamp is turned off.
vii