Nikon Eclipse Ni-E Instruction Manual page 177

(6) Configuring Other Functions (See DS-L3 Chapter 6 "6 Configuring Other Functions".)
(6-1) Ni-E Display Panel
(See DS-L3 Chapter 6 "6.1 Setting the Display of the Ni-E Front Display Panel".)
Set a display pattern to be displayed on the display panel of Ni-E microscope at the system startup.
The display pattern depends on the type of the motorized unit connected and is inclusive of 9 patterns. (See Chapter 3 "1
Display Panel Details - (3) Initialization completion display".)
<Factory setting>
"PATTERN 1"
Pressing the [DISPLAY Previous/Next] button brings up a
sub-screen prompting you to select a display pattern, therefore,
select a pattern by pressing the DISPLAY buttons on the Ni-E
main body then press the [OK] button.
Display switching between "microscope state"
and "FUNCTION button's function"
Pressing the DISPLAY switch button switches the status
display and the function display of the FUNCTION button.
(6-2) Enabling Z Control (See DS-L3 Chapter 6 "6.2 Enabling/Disabling the Operation of the Elevating
Section".)
Enable/disable the focus knob function that drives the elevating section of the microscope.
<Factory setting>
"Enabled"
It is set to "Enabled" when the button is checked.
(6-3) Buzzer
(See DS-L3 Chapter 6 "6.3 Turning ON/OFF the Buzzer".)
Set the buzzer ON/OFF when pressing a button of the microscope or the ergo controller.
<Factory setting>
Ni-E main body: "ON"
Ergo controller: "OFF"
It is set to "BUZZ" when the button is checked.
Chapter 3
Individual Operations
163
[SETUP MENU] → [UTILITY]
Display pattern setting
Enabling/disabling Z control
Buzzer ON/OFF