Nikon Eclipse Ni-E Instruction Manual page 176

(5) Set Mode Function (See DS-L3 Chapter 5 "2 Using MODE".)
In order to use the MODE function, "register" the motorized devices for the modes and "save" the status of the registered
motorized device. "Load" the saved mode on the [MICROSCOPY CONTROL] screen.
See Chapter 3 "19.1 MODE" in this document for the details on the MODE function.
(5-1) Register MODE (Add/Modify/Delete)
(See DS-L3 Chapter 5 "2.1 Registering/Changing Target Motorized Devices".)
(See DS-L3 Chapter 5 "2.4 Deleting a Mode".)
<Factory setting>
"Empty: No registration"
Specify a mode number to open a submenu. [ADD] button is
displayed for an initial registration and [MODIFY] and [DELETE]
buttons for a registration update, so follow the instruction on the
screen to enter a mode name (up to four alphanumeric
characters) and specify a target motorized unit.
When you "delete" the mode, its mode name will change to the
factory setting name (MD1 to MD4).
(5-2) Save the mode
(See DS-L3 Chapter 5 "2.2 Saving/Updating a Mode
(State of Motorized Devices)".)
After the mode has been registered, the mode name registered
for the [MODE (No.)] button is displayed and the [SAVE MODE]
button is displayed on the right of the button. Let the microscope
enter your desired microscopy state here, press the [SAVE
MODE] button, and then the current position and state (mode) of
the registered motorized unit will be saved.
You can also save the mode on the [MICROSCOPE CONTROL]
screen. See the following figure (5-3). Press the [SAVE MODE]
button to open the submenu. Set the desired microscopy state
using the microscope and press the corresponding mode
number button to save the current microscopy state of the
registered motorized device.
(5-3) Load the mode
(See DS-L3 Chapter 5 "2.3 Loading a Mode".)
The saved mode can be recalled on the [MICROSCOPE
CONTROL] screen.
Press the [LOAD MODE] button to open the submenu. Specify
the number of the mode to be loaded.
Chapter 3
Individual Operations
Specifying mode NO. → Adding/modifying/deleting mode
[LOAD MODE]
button
→ Press the [MODE (No.)] button for the mode to be
→ Press the [MODE (No.)] button for the mode to be
162
[SETUP MENU] → [MODE]
Registered mode
(Example: MODE1 and MODE2 registered)
[MICROSCOPE CONTROL] screen
[SAVE MODE]
button
Saving a mode [SAVE MODE] button
saved in the submenu.
Loading a mode [LOAD MODE] button
loaded in the submenu.