Nikon Eclipse Ni-E Instruction Manual page 179

(7) Maintenance
(7-1) FL Turret Drive Speed
(See DS-L3 Chapter 6 "6.5 Setting the Driving Speed of the Epi-Fluorescence Cube Turret".)
Set the drive speed of the epi-fluorescence cube turret to High or Low.
When a thick dichroic mirror is used for a filter cube, set the drive speed to "Low".
If you are using a two-layered epi-fluorescence cube turret, configure 1st and 2nd layers separately.
In order to perform this configuration, the motorized epi-fluorescence cube turret must be attached.
<Factory setting>
High for both the 1st and 2nd layers
(7-2) Resetting Data
(See DS-L3 Chapter 6 "6.6 Restoring the Factory Default Settings".)
Restore all settings made on the [MICROSCOPE SETUP MENU] to the default settings.
(7-3) Program Version
You can check the program version of the microscope system.
When you are using an ergo controller, the program version of
the ergo controller is displayed after [ERGC:].
When you are using the joystick controller, the program version
of the joystick controller is displayed after [JOY:].
Restoring the Factory Default Settings for Microscope Data (from the Microscope)
You can restore the setting data to the default setting with the button operation of the Ni-E microscope.
Use this method to restore objective device information to factory default.
<Procedure>
Turn on the power while holding down the following three
buttons on the front of the main body.
 DISPLAY Previous button
 DISPLAY Next button
 Z-RESET button
When successful, the display shown on right side appears
and data is restored to factory default.
Chapter 3
Individual Operations
(7-2)
Turning power switch ON while holding down three
165
[SETUP MENU] → [MAINTENANCE]
(7-1)
(7-3)
Maintenance Item Setting
Power switch ON
buttons
F L A S H D a t a I n i t i a l i z i n g .
Setting Data Restored to Default Setting