Nikon Eclipse Ni-E Instruction Manual page 172

Set the focus position to interlock with ALF (Parfocal Correction).
Press the [FOCUS POS. SET] button before specifying the
objective on the optical path, and focus it and press the [SET]
button.
Notes on settings
Set all addresses of the nosepiece. Set the same focus
position as the one for the previous objective at a position
where no objectives are attached. Otherwise, no parfocal
correction takes place when the address is switched from
the position without objective to the position with
objective. In addition, no parfocal correction takes place
when the address is switched from the position with
objective to the position without objective.
[SAVE]
Parameters adjusted with the [Intelligent] settings of the
"Aperture Diaphragm", "Field Diaphragm", and "ND Value"
will be reset once DS-L3 is powered off. In order to use the
[Intelligent] setting for the next microscopy, be sure to press
the [SAVE] button to save the settings.
■ ZOOM INTERLOCK
(See DS-L3 Chapter 6 "5.1.5 Configuring the Interlocked Operation with Switching of Zoom Magnification".)
When the field diaphragm and motorized ND filter wheel have
been set in the [OBJECTIVE INTERLOCK], this is to set either
"Interlock/Do not interlock" for those movement involved in
zooming.
■ PATH INTERLOCK
(See DS-L3 Chapter 6 "5.1.6 Configuring the Interlocked
Operation with Switching of Optical Path".)
When the field diaphragm has been set in the [OBJECTIVE
INTERLOCK], this is to set either "Interlock/Do not interlock" for
the movement of the field diaphragm involved in the optical path
switching of the motorized quadrocular tilting tube.
Chapter 3
Individual Operations
ZOOM INTERLOCK and PATH INTERLOCK settings
158
([FOCUS POS. SET] pressed)
Focus position setting
[SAVE] in [OBJECTIVE INTERLOCK] setting