Nikon Eclipse Ni-E Instruction Manual page 150

3
Loading a mode
(1) Press [FUNCTION1] and [FUNCTION2] buttons
alternately.
This assumes that a load function for MODE 1 and
MODE 2 is allocated to FUNCTION 1 button and
FUNCTION 2 button respectively. The MODE load
function is not set to a FUNCTION button in Ni-E
as default. See "23 Operation on DS-L3" - "23.1
Setting Up the Microscope - (3-1) Ni-E microscope
button" to reallocate the function.
(2) Saved differential interference contrast microscopy
and epi-fluorescence microscopy will be loaded
alternately.
You can work with on the DS-L3 [MICROSCOPE
CONTROL] screen.
Press the [LOAD MODE] button. Press [mdic] and [mfl]
alternately when a sub screen of the mode selection
(load) opened.
Saved differential interference contrast microscopy and
epi-fluorescence microscopy will be loaded alternately.
Loading a mode in Sleep mode
Loading a mode is not available in Sleep mode. A
message showing "Sleep mode is active.
Drive/operation not available" is displayed and
you hear a buzz. (Beep) The warning disappears
automatically approximately after 3 seconds.
Reset the sleep mode before you continue the
operation.
(See "23 Operation on DS-L3" - "23.1 Setting Up
the Microscope - (3-3) Buttons on the Screens on
DS-L3 -■ SLEEP Button" for details.)
Chapter 3
Individual Operations
Sleep mode is active Drive/operation not available
136
Loading MODE
_ _ _ _ m f l - _ _ _ _ M D 4 _ _ _ _ _
m d i c - _ _ _ M D 3 _ _ _ _ _ M D 5
Switched to the display of the
FUNCTION button function
[MICROSCOPE CONTROL]
Loading MODE
P A _ _ 2 * _ S L E E P _ M O D E _
[ E R 2 ] D e v i c e _ U n a v a i l a b l e .
M D 6
*