Nikon Eclipse Ni-E Instruction Manual page 82

Microscopy Procedure
Display at power ON
When the power is turned on, operation progress is
displayed on the front display panel of the main body.
When initialization completes, microscope's status
appears on the display panel. For details, see
Chapter 3 "1 Display Panel Details".
2
Turn on the dia-illumination lamp.
Press the dia-illumination lamp ON/OFF switch.
Turning lamp ON, brightness adjustment
control
The lamp can also be turned on and adjusted from
DS-L3 by configuring the lamp control button on the
DS-L3's [MICROSCOPE CONTROL] screen or
[CAM-MIC CONTROL] screen. When Ni-E is turned
on, control switches on the Ni-E are enabled.
To control from DS-L3, switch control to the DS-L3
side by pressing the [LAMP CTRL] button configured
on DS-L3. DS-L3 will have control when the button is
checked.
Chapter 2
Microscopy Operations
Preparation
Phase Contrast
1 2 3 4 5 6 7 8
68
Focus and Optical
Microscopy
System Adjustment
9 10 11 12 13 14 15 16 17 18 19 20 21 22 ■
_ N i - E _ V x . x x _ x x x x . x x x x . F 1
D a t a _ L o a d i n g . . .
Top: Model name, firmware version
Bottom: Program startup progress
_ N i - E _ V x . x x _ x x x x . x x x x . F 1
I n i t i a l i z i n g . . . . . . . . . . . .
Top: Model name, firmware version
Bottom: Motorized device initialization
progress
P A _ _ 2 x _ _ _ _
D I A : O N _ _ _ _ _ _ _ _ _ _
Microscope state display
Display pattern 1: Factory setting example
Turning on the dia-illumination lamp
P A _ _ 2 x _ _ _ _
D I A : O N _ _ _ _ _ _ _ _ _ _
Voltage is not displayed.
DS-L3 [MICROSCOPE CONTROL] top screen
[MIC] button: Switch to microscope control screen
[MICROSCOPE CONTROL] screen
[LAMP CTRL] button: Switch lamp control.
[LAMP ON/OFF] button: Turn on/off the lamp.
[ADJ.] button: Open the sub screen for brightness
control.
[PHOTO] button (on the sub screen):
Photomicrography voltage
■
Z : _ _ _ _ _ 0 . 0 0 0 u m
F S 3 0 . 0 m m
(1)
(2)
Z : _ _ _ _ _ 0 . 0 0 0 u m
F S 3 0 . 0 m m