Nikon Eclipse Ni-E Instruction Manual page 169

■ Enabling operation buttons
→(See DS-L3 Chapter 6 "4.2.5 Enabling/Disabling the Button Operation".)
Enable/disable the buttons located on the front and lateral
right/left on the base of the Ni-E microscope.
The buttons can only be configured as a group (front, lateral left,
lateral right) not individually.
<Factory setting>
All "enabled"
(3-2) Operation Buttons on Ergo Controller
(See DS-L3 Chapter 6 "4.3 Configuring the Function of the Ergo Controller Buttons".)
Change the function of buttons equipped with the ergo controller.
<Factory setting>
See Chapter 3, "20 Using the Ergo Controller" in this document.
Pressing the [FUNC SET] of the ergo controller displays the
button alignment of the ergo controller. Specify a button to select
a function.
The CW and CCW buttons in the middle have different functions
available for setting than other buttons.
(3-3) Buttons on the Screens on DS-L3
(See DS-L3 Chapter 6 "4.1 Configuring the Screen Buttons for DS-L3".)
Configure the buttons on DS-L3 screens.
■ Function Setting on the [MICROSCOPE CONTROL]/[CAM-MIC CONTROL] Screen
(See DS-L3 Chapter 6 "4.1.1 Selecting the Buttons to be Displayed".)
Up to 15 buttons can be aligned on the [MICROSCOPE CONTROL] screen and up to 12 on the [CAM-MIC CONTROL]
screen.
<Factory setting>
See DS-L3 Chapter 2 "3.1 [MICROSCOPE CONTROL] Screen
(Ni-E)" for the [MICROSCOPE CONTROL] screen.
See DS-L3 Chapter 2 "3.2 [CAM-MIC CONTROL] Screen
(Ni-E)" for the [CAM-MIC CONTROL] screen.
Chapter 3
Individual Operations
Button setting on DS-L3 [MICROSCOPE CONTROL]
155
Enabling/disabling Ni-E buttons
Selecting supported unit
(Ex.: When a upper left button is pressed)
screen
(Example of specifying Nosepiece → Objective)