Moving The Machine - Ricoh D093 Service Manual

Main Machine Installation (D093/D094)
the winter.
Please remind the customer that the anti-condensation heater consumes an additional
26W when it is switched on.
The heaters operate after the machine is switched off with both the operation power switch
and main power switch. However, in order for the heaters to function, the machine must
remain plugged into the power mains.

3.2.5 MOVING THE MACHINE

If you will move the main machine to a different building, open the paper feed section and
push the cleaning blade lever to the left. This keeps the cleaning blade away from the drum
while you move the main machine.
If you will move the main machine to a different location in the same building, it is not
necessary to set the lever to the left, and it is not necessary to disconnect the main
machine from the roll feeder or table.
Always push low on the roll feeder or table to move the main machine.
If you push on the main machine, you could twist and possibly damage the bottom
of the main machine.
Never push on the main machine while it is installed on top of the roll feeder or
table.
To prepare the main machine for transport to a different building, disconnect the main
machine and the roller feeder (or table). Attach the drawer to the frame with tape, or the roll
feeder drawer will fall out of the table frame.
Lift the main machine with one person on each end of the main machine. Be sure to use the
handles in recesses on the sides of the main machine.
To prevent developer and toner spill, never tilt the main machine more than 30° from the
horizontal.
If the machine must be tilted more than 30° remove the development unit and toner
cartridge before moving the machine.
Never tilt the machine more than 45° from the horizontal.
When the machine is moved, never expose the machine to temperatures above 40°C
(104°F).
If the machine needs to be stored temporarily it should be stored where the temperature is
within the range 30° to 40°C (86° to 104°F).
The machine should not be stored longer than one month with developer/toner inside the
machine.
D093/D094 3-30 SM