Connecting The Main Machine And Roll Feeder - Ricoh D093 Service Manual

Roll Feeder (D503/D504)
If the machine is not level, use a wrench to adjust the nuts on each foot to raise or lower the
main machine at each corner.
The main machine must be level side-to-side within ±0.15/m.
Normally, the adjustment with the level on the exposure glass is not required.
However, if you have to do the adjustment with the level on the exposure glass, go
back to Step 5 and do the adjustment again with the level on the development unit.

Connecting the Main Machine and Roll Feeder

1. Remove the rear cover [1] of the main machine (
2. Remove the cover of the controller unit [2] (
3. Remove the shield cover [1] (
D093/D094
x2).
x1).
x 8).
3-42 SM